GE Druck ADTS 405 F Mk2, Инструкция по эксплуатации

Страница: 106 / 140

Chapter 7. Reference
88 | ADTS 405 R/F Mk2 Instruction Manual-English © 2017 General Electric Company – All Rights Reserved.
7.3.13 SETUP, SPEED, [CAS/TAS]
1. This function changes the airspeed display between Calibrated Airspeed (CAS or Vc)
and True Airspeed (TAS or Vt). For testing purposes, CAS is equivalent to Indicated
Airspeed (IAS).
2. The value of TAS displayed depends on the Pt temperature, see Section 7.3.14,
“SETUP, SPEED, [Pt TEMPERATURE],” on page 88.
7.3.14 SETUP, SPEED, [Pt TEMPERATURE]
The function allows the value of Pt temperature to be entered, this is used in the calculation
of TAS.
a. Enter the pitot temperature measured by the aircraft's pitot temperature sensor in
the units shown on the display.
b. The default units of temperature measurement may be changed using CONFIG,
[UNITS], [TEMPERATURE].
7.3.15 SETUP, MACH
This function allows the Mach limit to be changed or disabled. The initial Mach limit comes
from the current aircraft limits. To change the limit enter a numeric value or select as follows:
a. Select [OFF] to disable the Mach limit.
b. Select [ON] to enable the Mach limit.
c. Select [DEFAULT] to restore the Mach limit from the aircraft limits in use.
7.3.16 SETUP, RATE TIMER
This function allows the Wait/Time values to be set for F1, F2, and F3 of the RATE TIMER
function. To change the times:
a. Select the function to be changed: F1, F2 or F3.
b. Enter the [WAIT] value in minutes and seconds.
c. Enter 00:00 if a wait is not required.
d. Select [TIME].
e. Enter the [TIME] value in minutes and seconds.
f. Press CLEAR/QUIT .
g. Select another WAIT/TIME or press CLEAR/QUIT .
7.3.17 SETUP, RATE
This function selects automatic airspeed rate control ON or OFF. If the automatic airspeed
rate is selected (using
SETUP , RATE ) the airspeed rate is automatically adjusted to
simultaneously achieve both altitude and airspeed aim. This adjustment normally requires a
reduction in the rate from the aim value; the rate does not exceed the aim value. When
airspeed is automatically reduced, the display shows RATE CAS aim as (A).
This function only applies when using Aeronautical units:
• ft and kts