GE DigitalFlow GS868, Руководство для стартапов

Страница: 31 / 81

March 2008
2-2 Initial Setup
Accessing the User
Program
To access the User Program , press the
[PROG]
key on the keypad.
Note:
If the security feature is active, enter the password and press
the
[ENT]
key to enter the User Program . See the
SECUR
submenu section in Chapter 1, Programming Site Data , of the
Programming Manual for more information.
For a 1-Channel Model GS868, the measurement mode screen is
replaced by the following initial programming mode screen:
For a 2-Channel Model GS868, the following two-step sequence is
required to reach the initial programming screen:
Only the submenus
ACTIV
,
SYSTM
and
PIPE
are discussed in this
manual. Refer to the Programming Manual for information on the
other submenus.
Note:
In this manual, only the programming of Channel 1 will be
described. To program Channel 2, simply repeat the same
procedures presented for Channel 1.
PROGRAM Start At the User Program screen
shown, press the
[F1]
function
key and proceed to “Activating a
Channel” section on page 2-3
for instructions.
PROGRAM
status
ACTIV SYSTM PIPE I/O
PROGRAM Start Press
[F1]
or
[F2]
to select the
submenu for Channel 1 or
Channel 2, respectively, from the
option bar.
PROGRAM
Channel 1
CH1 CH2 GLOBL SAVE
Chan 1 PROGR Start
At the User Program screen
shown, press the
[F1]
function
key and proceed to “Activating a
Channel” section on page 2-3
for instructions.
Channel PROGRAM
status
ACTIV SYSTM PIPE I/O