GE DigitalFlow DF868, Руководство по программированию

Страница: 61 / 184

Programming Site Data 1-53
March 2008
Option Card RTD Inputs
Option cards with RTD inputs have a temperature range of –100 ° to
350 °C. Complete the following steps to set up the two RTD inputs of
an option card installed in Slot x:
1. Press
[F1]
to set up RTD input A or
[F2]
to set up RTD input B.
Note:
The set up of RTD input A is used as an example. Identical
procedures would be used to set up RTD input B.
2. Enter a Label of up to eight characters for input A and press
[ENT]
.
3. At the Input Measurement prompt, press
[F1]=OFF
to disable RTD
input A and return to the previous prompt, or press
[F2]=TEMP
to
enable RTD input A.
4. Enter a value for the Base (low) end of the chosen input range and
press
[ENT]
.
5. Enter a value for the Full Scale (high) end of the chosen input
range and press
[ENT]
.
6. Press
[F1]
-
[F2]
to set up another input or press
[EXIT]
to select
another slot for set up.
Procedure Options
After completing the above steps, the meter returns to the
Global
PROGRAM
. Continue as follows:
•
To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
•
To leave the
User PROGRAM
and retain the previous settings, press
[EXIT]
twice and then press
[F1] = NO
at the
SAVE
prompt. Any
programming changes will be discarded and you will be returned
to the data display
.
•
To leave the
User PROGRAM
and return to measurement mode, press
[EXIT]
twice and then press
[F2] = YES
at the
SAVE
prompt. Your
programming changes will be entered into the meter’s memory,
and you will be returned to the data display.