VSR
User Manual
10
Alarm Record Reset
This feature is for future development, and has not yet been implemented.
Error Out
The Error Out signal is activated when the unit experiences any operational or internal error.
Video Loss Out
The Videoloss Out signal is activated when the unit experiences videoloss on the video input (Composite). In
the event of videoloss,
VIDEOLOSS
will be indicated near the upper left hand corner of the primary monitor.
Videoloss is defined as the inability to successfully lock on either horizontal or vertical sync frequencies at the
video inputs.
Disk End Out
The Disk End Out is activated when there is less than 1% of recording space left on the hard disk. The VSR
must be in Record mode and
not
set to Continuous Overwrite.
Power Connector
Plug the power cord into the power cord connector and then into a properly rated wall socket. Once power is
applied to the unit, it will begin its power-up procedure. The unit will begin by displaying the software version
on Monitor-A, then the unit will begin recording automatically.
Ethernet Port
The cable connection configuration for the ethernet port depends on your network configuration:
•
For a VSR that connects directly to a hub, use a straight through connection.
•
For a VSR that connects directly to a PC, use a cross-over connection.
Table 6.
Power supply rating
Power supply
Voltage Input
100-240 VAC 50-60 Hz, auto-ranging
Amps
1.65-0.85 A
Voltage Output
12 VDC
Connector
2.1 mm barrel, center positive
Содержание VSR-300
Страница 1: ...GE Security VSR User Manual ...
Страница 17: ...13 Figure 6 Typical network setup ...
Страница 78: ...VSR User Manual 74 ...