DU-WS-0012-01 Rev B 5/24/16 GCX Corp. Page 11 of 15
Place the left and right cable bundles into the corresponding track of the Cable Cover (Note: Larger Cables should be
placed in first)
–
Figure A
. Route the cable bundles over the Rear Cable Support. Insert the rear end of the Cable Cover
into the two (2) mating slots located below the Arm
–
Figure B
.
Pivot the Cable Cover up towards the Arm
–
Figure C.
Gently squeeze the front of the Cable Cover and insert tabs of the
Cable Cover into the mating slots to secure the Cable Cover
– Ensure the Cable Cover is engaged in the mating slots –
Figure D
.
1/2” (13mm)
Secure cable bundle to rear Cable Anchor
with cable tie 1/2” (13mm) from the end of the
Cable Sleeve. Clip excess length of the cable
tie as flush as possible to avoid creation of a
sharp edge.
Figure A
Figure B
Figure C
Figure D
Rear Cable Support