Component
Application
Cutting Box
Honeycomb Table
Material Support
Stands
Thin, Flexible Materials
Required Required Not
Required
Thick, Firm Materials
Required Not
Required
Required
NOTE
Advanced users may choose to try other component setups to suit their particular
engraving / cutting techniques or working material. Feel free to explore different ways to
setup the various SmartBOX components to adapt to the results you wish to achieve.
INSTALLATION / OPERATION (Cutting Box and Honeycomb Table):
1) Open the front pass-through door and lower the X380’s worktable to the lowest possible position
through the X380 control panel.
2) Insert the cutting box and attached honeycomb table through the open front pass-through door
onto the worktable, with the air extraction opening facing towards the back end of the X380.
Ensure the rear and left side of the cutting box is aligned flush to the edges of the left and right
rulers on the worktable.
3) Open the honeycomb table to find the four screw holes at the bottom of the cutting box. With the
included thumbscrews, secure the cutting box to the work table and close the honeycomb table.
4)
[OPTIONAL]
If you have an air extraction system option installed, then you will need to attach the
air extraction system’s pipe connector to the SmartBOX’s air extraction opening from the X380’s
rear side. (For detailed instructions to setup the air extraction system, please see the AIR
EXTRACTION UNIT section in section 7.1).
Congratulations, you are now ready to position your thin, flexible materials on top of your honeycomb
table / cutting box and start working.
INSTALLATION / OPERATION (Cutting Box and Material Support Stands):
1) In order to use the cutting box along with the material support stands, you must first remove the
honeycomb table from the cutting box. Before you position the cutting box in the LaserPro
SmartCut X380, first unscrew the screws that attach the hinges of the honeycomb table to the
cutting box.
2) Remove the honeycomb table. Please keep in mind the honeycomb table surface is fragile;
therefore, it is suggested to keep it in a safe place.
3) Open the front pass-through door and lower the LaserPro SmartCut X380’s worktable to lowest
possible position through the X380 control panel.
4) Insert the cutting box through the open front pass-through door onto the worktable, with the air
extraction opening facing towards the back end of the LaserPro SmartCut X380. Ensure the rear
and left side of the cutting box is aligned flush to the edges of the left and right rulers on the
worktable.
5) Find the four screw holes at the bottom of the cutting box. With the included thumbscrews, secure
the cutting box to the worktable.
6) On the front right hand side of the cutting table, there will be a metal guard, which must be
swiveled so that it is perpendicular to the front side of the cutting table (as shown in the picture
below). This allows the LaserPro SmartCut X380 to properly account for the extra height the
cutting table adds to the cutting table.
- 70 -
SmartCut X380 User Manual
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | [email protected] | www.JORLINK.com
