GCC Technologies Jaguar IV Series, Руководство пользователя

Страница: 50 / 166

Jaguar IV User Manua
l
Operation
4-7
4.3 Cutting Force and Offset Adjustment
Before sending your designs for cutting, you may perform a “cut test” to generate satisfactory
cutting results. The “Cut Test” should be repeated until the appropriate cutting conditions for the
media are discovered.
After sizing the media, press [CUT TEST] button to select the “square cut”, and press [ENTER
KEY] to confirm.
The default cutting force and offset value of the cutting test are 80gf and 0.275mm respectively.
Press [ARROW KEY] to move the tool carriage to the position where you like. Then, press the
[ENTER KEY] to perform Cut Test.
Note: At the same time, the new origin is also set at the cutting test position.
When the cutting test is completed, a pattern appears. Peel off the pattern to see if it can be
easily separated from the media base. If yes, the setup tool force is appropriate. If not or cut
through the back paper, press [FORCE KEY] to adjust the tool force until an optimum force is
obtained (Figure 4-14).
If the pattern appears to be BB or CC layout,
press [OFFSET KEY] to adjust the offset
value until AA pattern discovered.
S q u a r e C u t
Press ENTER_KEY
A A CC BB
Press ENTER_KEY
E n t e r : O K S e l e c t :
M o v e t t e c u
X Y : :
M s t
S q u a r e C u t
Press SPEED_KEY ,
FORCE_K EY,
OFFSET_KEY to setup
or
Press arrow keys to
desired position for next
square cut
E n t e r : O K
C o n t
/ N : O O F F N
M achine
3mm
80
m
m
3mm
80
m
m
Press ENTER_KEY
80
m
m
Finish square cut
Press
ENTER _KEY
Press ON /O FF
line_K EY
i n o u s
L N I E
Figure 4-14