GBR Systems M-40, Руководство оператора и по обслуживанию

Страница: 152 / 161

M-40 OPERATOR & SERVICE MANUAL ISSUE 05/01 ADJUSTMENTS
SECTION D – PAGE 5
D.1fc Rotating Singulator Roller
The Singulating Roller is the place where the highest frictional forces are
created. These frictional forces wear down the Singulating Roller. This
requires that the Singulating Roller be rotated approximately every 500,000
sheets fed, depending on paper type and operator’s adjustment of the
singulator.
More frequent rotation may be necessary if correct
adjustments were not maintained.
1. Raise Singulating Roller off the auxiliary Singulating Rollers and belt.
2. On left-hand side of the Singulating Roller loosen the setscrew which
keeps the Singulating Roller from rotating.
3. Loosen the two screws for the stainless steel brake plate.
4. Rotate the Singulating Roller to expose a new wear surface (rotate about
1/4 inch). The worn surface should be rotated forward. This will prevent
the worn surface from coming in contact with paper that is being fed into
the singulation point.
5. Secure all three screws.
Singulator Roller Rotation
Singulator Roller Parallelism
LOOSEN TWO BRAKE
PLATE SCREWS
LOOSEN SET SCREW
(USE STRIPS OF
PAPER BOTH ROLLERS)
ORANGE FEED
ROLLERS
BLUE
SINGULATOR
ROLLER
SINGULATOR CROSS BAR
PARALLEL