GBR Systems M-40, Руководство оператора и по обслуживанию

Страница: 135 / 161

M-40 OPERATOR & SERVICE MANUAL ISSUE 05/01 MAINTENANCE
SECTION C – PAGE 2
C.1 DAILY MACHINE MAINTENANCE DUTIES
At the beginning of each day of operation the following simple steps should be
followed:

Perform folder and glue cleanup procedures

Purge the side glue guns (see Section B)

Purge the flap glue nozzles (see Section B)

Return the glue settings to normal start of day settings

Run several sample documents to check quality

Reset the batch counter in batch code
1. Remove buckle plates and the bypass plates.
Fold Plate Removal
2. Clean the folder with Spudger and Cleaning Tool.
Inspect all undercut areas in the rollers for glue build up and carefully
remove the glue residue. The areas that are in line with the side glue guns
and the flap glue dots have been covered with a nonstick tape to make
cleaning as easy as possible. Special tools called a Spudger and a Cleaning
Tool are shipped with each machine for the operator to use. These tools
gently remove the glue buildup on the taped areas and any other paper path
surfaces.
Fold Roller Cleaning Tools
NOTE: Rotate folder rollers using the large red knob on the right
side of the folder in the direction of the arrows embossed on the
knob. Proper rotation of the folder rollers will prevent damage to
the tape.
After removing as much dried glue from the folder rollers as is
possible, wipe all folder rollers with a cloth. Partially saturate the
cloth with warm water, or Bio-T solution, to wet down the rollers.
The wetting procedure is necessary to soften the hardened glue
and permit easier removal. Leave the folder rollers wet while
doing the following steps: this will facilitate roller cleanup.