GBC 4064WF
Operation Manual
© 2005 General Binding Corporation
Page 12
Heated Main Rollers:
(Fig. 9 – Item A)
Silicone rubber coated steel tubes heat the
laminating film and compresses the heated
film to the items being laminated. Heat is
provided by an internal heating element.
Pull Rollers:
(Fig. 9 - Item B)
The Pull Rollers located at the back of the
laminator are motor driven. They
simultaneously pull the film and improve the
quality of the lamination.
Pressure Plate:
(Fig. 10 – Item A)
The Pressure Plate mounted to the front of
the table helps hold down the image as it
enters the Nip Area.
Table Idler:
(Fig. 10 – Item B)
The Table Idler is used to assist in bringing
the material up to the nip.
The table Idler is helpful in roll to roll
operation and helps move large ridged panels
through the nip.
Main On / Off (I/O) Switch:
(Fig. 11 – Item A)
Located on the lower back of the control
panel side of the GBC4064WF is the main
power switch.
“I” means ON, “O” means OFF
.
Figure 9
Figure 10
Figure 11
A
B
A
B
A
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
