GBC Falcon 60+, Руководство по эксплуатации

Страница: 27 / 41

Operations Manual
Page 26
©2004 General Binding Corporation
FALCON
60+ (-1)
CE
Start Laminating
1. At this point you should have your laminator webbed
with the appropriate material for your application.
2. The safety shield and feed table should be in the
normal operating position.
3. The main rollers should be open and the pull rollers
should be closed.
4. Speed is set to 3 or less and forward () motor direction
is selected.
5. Press the start ( ) button.
6.
Set main roller pressure between 40 - 50% for lami-
nating.
CAUTION:
If using PSA film, an air pocket may result
between the main rollers and pull rollers. Raise the pull
rollers to allow the air pocket to pass.
7.
Make any necessary film brake tension, pull/ main
roller pressure, clutch and/ or rewind brake tension
adjustments.
8.
Position the item to be laminated on the feed table.
9.
Align the leading edge of the item square to the heat
roller nip (Figure 28).
10.
With both hands and an outward force push the image
slower than the speed of the rollers into the nip of the
heat rollers (Figure 29).
CAUTION:
Avoid forcing the image into the main roller nip
as this action will cause the corners of the leading edge
to buckle and create a wave.
Fig 28
Fig 29