GBC Falcon 60+, Руководство по эксплуатации

Страница: 25 / 41

Operations Manual
Page 24
©2004 General Binding Corporation
FALCON
60+ (-1)
CE
Webbing Thermal Film Using
Threading Card
The following procedure uses the film threading card
provided with new rolls of GBC film. The laminator rollers
will be hot for this procedure. For pressure sensitive film
(PSA), refer to the section entitled WEBBING USING FILM
THREADING CARD FOR PSA FILM.
1. Turn the Power ON/OFF to on (I) .
2.
Set top and bottom temperature with regards to the
film type used.
3.
Ensure no brake tension is applied to the film
shafts.
4.
Remove the safety shield and pivot the feed table
down.
5.
Pull the top roll of film down under the upper idler bar and
allow to drape over the top heat roller (Figure 22).
6.
Pull the lower film behind the lower idler bar and
up towards the film draped over the top heat roller
(Figure 23).
7.
Use a threading card to push the two materials into
the heat roller nip.
8.
Pivot the table back to it’s feeding position while
ensuring the threading card is on top of the feed table
(Figure 24).
9.
Use the main roller pressure handle to bring the main
roller to initial contact with the threading card.
10.
Replace the safety shield.
11.
Set speed to 3 or less.
12.
Ensure forward ( ) is selected for motor direction
and press the start ( ) button.
13.
From the rear of the machine, guide the web over the
chill idler, if installed, and through the pull rollers.
14.
Once the web has entered the pull roller nip, use the
pull roller pressure handle to close the pull roller nip.
15.
Once the threading card has completely exited the
pull rollers, press the stop ( ) button.
16. Open the main roller nip.
17.
Now refer to the section entitled
START
LAMINATING.
Fig 22
Thermal
Laminate
Thermal
Laminate
Fig 23
Thermal
Laminate
Thermal
Laminate
Fig 24