GBC Falcon 60+, Руководство по эксплуатации

Страница: 30 / 41

Operations Manual
Page 29
FALCON
60+ (-1)
CE
©2004 General Binding Corporation
Applications
Tips For Pre Coating Boards
(Figure 34)
1. Load the laminator as illustrated in Figure 34. Remove
chill idler.
2. The width of the roll should not exceed the width of the
board by more than 1/2 in. (1.3 cm).
3. Use a leader board to set the main roller and pull roller
pressure prior to webbing.
4. Use a leader board to start the run and a trailer board
to finish the run.
5.
Using the pull rollers will allow you to leave gaps
between boards.
6.
If not using the pull rollers, have the boards nearby to
butt end to end during feeding.
Tips For Mounting Pre Coated Boards
(Figure 35)
1.
This application can also be performed from the rear
operating position.
2.
Use a leader board to set the main roller pressure prior
to mounting the image.
3.
Ensure the chill idler is removed and the rear slitter is
to one side.
4.
Heat, 125°F (52°C), may assist the process and increase
output quality.
5.
Do not stop once you have started the mounting process
through the machine.
Tips For Single Sided lamination
(Figure 36)
1. Load the laminator as illustrated in Figure 36.
2. Use kraft paper for one-sided lamination whenever the
items to be laminated are narrower than the film you
are using.
3. If not using kraft paper, use a scrap piece to finish the
run or you will have adhesive on your rollers.
4. For high volume runs, use Kraft paper and the lower
rear rewind for roll to roll operation.
5. Running the web over the chill idler may improve the
flatness of the output.
6. A little heat, 125°F (52°C), may help eliminate silvering
effects associated with PSA films.
Fig 34
Imag
e
Pre-coated baord
Release liner
Fig 35
Fig 36