GBC Falcon 60+, Руководство по эксплуатации

Страница: 22 / 41

Operations Manual
Page 21
FALCON
60+ (-1)
CE
©2004 General Binding Corporation
V. FOOTSWITCH: To operate using the footswitch, there
are a number of factors that determine how the machine
runs based on the position of the key on the Hand – Foot-
switch Control and if the safety shields are in place or not.
Refer to the chart below for settings and speeds.
Selector key
position
Safety shield on
(Latch locked)
Safety shield off
(Latch Unlocked)
Clockwise
Foot –Pedal:
Limited speed of 3f/m or
1m/m
Foot –Pedal:
Limited speed of 3f/m or
1m/m.
Control panel run switch:
Limited speed of 3f/m or
1m/m.
Control panel run switch:
Limited speed of 3f/m or
1m/m.
Counter
Clockwise
Foot –Pedal: Up to Max
speed.
Foot –Pedal: No function.
Control panel run switch: Up
to Max. speed.
Control panel run switch: No
function.
Selector key
removed
(Key removed
when turned
counterclockwise)
Foot –Pedal:
Up to Max speed.
Foot –Pedal:
No function.
Control panel run switch: Up
to Max. speed.
Control panel run switch: No
function.
W. REAR TABLE LATCHES:
(Figure 17) Located under
the left and right sides of the rear table.
X. REAR TABLE:
(Figure 17) Provides a working surface
when operating the machine from the rear. This table may also
be lowered when webbing for roll to roll applications.
To lower, pull the left and right side rear table latches in
and lower the rear table.
Y. REAR RUN/ STOP SWITCH:
(Figure 18) Located
on the right side of the laminator from the rear operating
position. This switch permits run (1) / stop (2) control of
the motor from the rear operating position.
Z. FILM WEB:
Laminating film loaded into the machine
(Not Shown).
AA. NIP POINT:
The point at which the top and bottom
rollers come into contact. The Nip Point of the heat rollers
is the place at which the items for lamination are introduced
into the laminator (Not Shown).
AB. REAR SLITTER:
(Figure 19) Used to cut off the
laminated web. To use, push down on the blade engage
lever (1) and slide across the rear slitter rail (2) to the
opposite side.
AC. SEPARATOR BAR:
(Option) (Figure 19) Required if
running Accushield™ material. To install, remove the rear
slitter and position the separator bar in it’s place.
(Falcon 60+ (-1) Part # 2020577)
(W)
(X)
Fig 17
(1)
(2)
(Y)
Fig 18
(1)
(2)
(AB)
(AC) - Option
Fig 19