Page 4 - 9
Installation
Digital Feeder Operation and Maintenance Manual
© GBC Pro - Tech February 2000
4.6 Set up
Follow the set up procedure to properly separate
the conveyor from the feeder, preparing the laminator and
installing the conveyor.
Tools required
• Tape measure
• A second person
• A third person
• Side cutters
• #2 Phillips screw driver
Separating the conveyor
a) Set the front side of the feeder approximately
49
inches ( 124 cm ) from the front of the
Explorer
107 Laminator.
49 in.
( 124 cm )
b) Remove the accessory bag secured to the top
of the conveyor and set it aside for now.
Accessory bag contents:
• Thirteen ( 13 ) Metal balls
• One ( 1 ) Encoder cable
• One ( 1 ) pneumatic hose
c) Cut the two banding straps securing the
conveyor to the sheet table of the feeder. Refer
to Figure 4.6.1 Banding straps
CAUTION
Do not use a knife or other sharp objects
to remove the strapping / ties from around
the machine. You can cause
damage to the equipment.
Figure 4.6.1 Banding straps
Banding straps
