GBC 44DT, Руководство по установке и эксплуатации

Страница: 17 / 37

Operating Instructions
Page 5-4
44DT
IMPORTANT:
To change from a process where only
the top roller is heated to a process that requires
heat on both rollers, you must first turn off the
laminator and allow the top roller to cool to room
temperature. Once the roller is cool, both rollers can
be heated simultaneously. See
General Operation in
the Operation chapter.
TEMP –
Press the up or down arrow buttons to
increase or decrease the temperature. When the
bottom heat roller is turned off, these buttons set the
top roller temperature only. When the bottom heat
roller is turned on, these buttons set the temperature
for both rollers, if they are heated from room
temperature.
SPEED –
Press the up or down buttons to set the
speed It is adjustable from 2.5 to 10 feet per minute
(fpm) (0.8 to 3 mpm).
FAN –
Turns the cooling fan on and off. Illuminates
when the fan is on.
REVERSE –
Press and hold the
REVERSE
button
to reverse the direction of the rollers. Release the
button to stop.
RUN –
Press and release the
RUN
button for
continuous running. The safety shield must be
installed.
WARNING:
Keep your fingers and hands
away from the nip point (the point where the upper
and lower rollers meet). Failure to observe this
warning could result in severe personal injury.
STOP –
Press the
STOP
button to stop the laminator.
MEAS.
– Press and hold the button to show the
actual temperature of the top heat roller on the LCD.
P
ULL
R
OLLERS
(Not shown.) The pull rollers, located at the back of
the laminator, are motor driven. They simultaneously
pull the laminate and improve the quality of the
laminated item.
P
OWER
S
WITCH
Fig. 5-6. Back of Laminator.
The power switch is located at the back of the
machine. Press the “
I
” on the switch to turn it on.
The LCD will illuminate on the control panel. The off
position, marked “
0
”, turns the machine off.
C
IRCUIT
B
REAKER
Electrical safety device which can be reset by the
operator if tripped.
Power switch
Circuit breaker