GBC 44DT, Руководство по установке и эксплуатации

Страница: 18 / 37

Page 6-1
Operating Instructions
44DT
This chapter describes how to use the laminator to:
Operate the machine
Load films (web the machine)
Laminate items
Mount items
G
ENERAL
O
PERATION
These instructions assume that the films have been
loaded. For information about loading films, see the
Loading Film section in this chapter.
Fig. 6-1. Power Switch on the Back of The Machine.
Fig. 6-2. Roller Pressure Handle.
•
•
•
•
To run the laminator:
Turn the laminator On (
I
) with the power switch
located at the back of the machine.
WARNING:
Make sure the safety shield and
feed tray are in their proper positions. You could be
burned and your fingers and hands could be trapped
and crushed in the hot rollers.
. Clothing, jewelry, and
long hair could be caught in the rollers and pull you
into them.
Set the roller pressure handle for the thickness of
the item that is to be laminated or mounted.
Fig. 6-3. Control Panel.
Do any of the following.
If using thermal films, turn on the bottom
heat if needed, and then use the
TEMP
up or down buttons to set the desired
temperature.
If using PSA films, go to the next step.
1.
2.
3.
a.
b.
6. O
PERATION
TEMP SPEED
BOTTOM
HEAT
FAN
STOP
RUN
TEMPERATURE
REVERSE
MEAS.
OFF
ON
9
SPEED
°F
220
READY
Power switch