Page 15 of 25
5.3
110VAC Power Connector
5.3.1 9-pin connector Details
Connector on the wiring loom: TE Connectivity /Amp Mate-N-Lock 9-pin Female Pin
P/N 170362-1, with male crimps P/N 172169-1
Pin
Function
1
120 VAC Neutral Inhibit.
2
120 VAC Neutral Enable.
3
120 VAC Hot Enable.
4
120 VAC Hot Power
5
No Connection
6
120 VAC Neutral Power
7
Bill Acceptor Relay Contact (Normally Open)
8
Bill Acceptor Relay Contact (Common)
9
No Connection
Ground
Ring terminal should be screwed to the
grounded frame
5.3.2 Output Relay Rating
CONTACTS Ratings
(Resistive load):
Max. switched power: 30 W or 250 VA
UL Rating:
2 A at 125VAC General Use
1 A at 30 VDC Resistive
GENERAL DATA
Life Expectancy
Minimum operations
Electrical
1 x 10
5
at 2 A 120 VAC Res.
Operate Time (typical)
5 ms at nominal coil voltage
Release Time (typical)
1 ms at nominal coil voltage
(with no coil suppressions)
Note 1
): All values at 20°C (68°F).
Note 2
): Please observe AWG current carrying capacity limits.
5.3.3 High Voltage Enable
The ST1C can be enabled or inhibited using the 9-pin connector as follows:
Pin
Function
1
110 VAC Neutral Inhibit.
Connect to 120 VAC Neutral to disable
acceptor. If this is left floating, it may disable
acceptor, based on the state of the 120VAC Hot
Enable line.
2
110 VAC Neutral Enable.
Connect to 120 VAC Neutral to enable acceptor.
Leave floating to disable acceptor.
3
110 VAC Hot Enable.
Connect to 120 VAC Hot to enable acceptor.
Leave floating to disable acceptor.
Note:
You should connect only one of these three pins.
Power & Signal
Loom Connector
(Host Side)
1
7
3
9
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099
