4
7
Installation
Caution! PROPRIETARY WIRING SYSTEM. Use Hawthorne cord set model HGC906147, HGC906148, or HGC906458 only for
connection from the luminaire power inlet to a standard junction box for power connection.
Attention! SYSTÈME DE CÂBLAGE PROPRIÉTAIRE. Utilisez le jeu de cordons Hawthorne modèle HGC906147, HGC906148
ou HGC906458 uniquement pour la connexion de l'entrée d'alimentation du luminaire à une boîte de jonction standard pour la
connexion électrique.
Warning! Mounting and installing of the LED fixture may only be executed by certified service personnel, in accordance with
the applicable local laws and regulations.
Warning! The installer is responsible for correct and safe installation.
Warning! Ensure the local cabling can support the voltage and current requirements of the LED fixture.
Warning! Avoid coiled cords and keep mains leads separated. This prevents electromagnetic interference.
Warning! Do not connect or disconnect the LED fixture under load.
7.1
Installation preparations
Warning! Mount the system to something that can hold the weight of the LED fixture.
•
Switch off mains power.
•
Install the Gavita Rail System Hanging Bracket (fig. 3) (sold separately). Or install the Wire Hangers (fig. 1B).
•
Make sure power cords:
1) Are not concealed or extended through a wall, floor, ceiling, or other parts of the building structures
2) Are not located above a suspended ceiling or dropped ceiling.
3) Are not permanently affixed to the building structure.
4) Are routed so that they are not subject to strain and are protected from physical damage.
5) Are visible over their entire length.
6) Are used within their rated ampacity as determined for the maximum temperature of the installed environment
specified in the instructions.
Installing the LED fixture
The Gavita Pro RS 2400e offers multiple mounting points for increased versatility. When using the Gavita Rail System Hanging
Bracket (fig. 3) (sold separately), use the innermost mounting point (fig. 4A). If utilizing Sungrips ratchet style rope hangers,
included mounting hardware, or hanging from a single point; utilize the outermost mounting point (fig. 4B). Note: when
mounting from a single point, utilizing the outermost mounting points will allow the fixture to completely unfold and remain
flat.
•
Hang the LED fixture to the mounting system.
•
Distribute weight evenly and ensure the LED fixture is the appropriate distance above crop height (fig. 5).
•
If using the LED fixture as a stand-alone device, continue to Section 7.4.
•
If using the LED fixture with a Master Controller, continue to Section 7.3.
To install additional LED fixtures, repeat sections 7.1 and 7.2 for each device.
3.
4.
5.
640W
60 cm
23 in
750W
0.75 m -
30 in
800W
A
A
B
B
A
A
B
B
