GA600AC Sliding Gate Opener User Manual
6
Step 2 - Checking Manual Release
·
Insert the key and open the manual release bar to enable the motor get into manual mode and
check that the motor output gear rotates freely by hand (Figure 6).
Figure 6
Step 3 - Removing / Installing Motor Cover
·
Unscrew the two cover screws located at each side of the motor cover.
·
Remove the rubber grommet below the limit switch (Figure 7).
Figure 7
Please Note: the rubber grommet must be fitted back onto the motor cover once the
cover has been re-fitted/replaced onto the base of the motor.
To make the motor into manual mode,
remove the slide cover, insert the key and
open the manual release bar.
In manual mode, the gear can turn freely
and the gate can be operated by hand.
