GA600AC Sliding Gate Opener User Manual
10
The limit switch stops are designed to set the desired opening and closing position of your gate.
These limit switch stops are designed to come into contact with the spring/magnetic limit switch.
It is extremely dangerous that without or incorrect installation of the limit switch stops can cause
crash of gate, damage of internal structure of the motor, moreover, the gate may slide off the guide
rail.
Setting the Limit Switch Stops
Closed Position
·
Position gate 150-200mm back from
the gate end catch closed position. This
will help in making sure you do not slam
the gate into the end stop/catch when
setting the closed position under power.
·
Fit limit switch stop onto the top of
gear rack at the point where it meets the Spring limit switch on the motor.
·
Tighten locking screws of limit switch stop.
Open Position
·
Position gate 150-200mm back
from the gate stop open position.
This will help in making sure you do
not slam the gate into the end
stop/catch when setting the open
position under power.
·
Fit limit switch stop onto the top of gear rack at the point where it meets the Spring limit switch
on the motor.
·
Tighten locking screws of limit switch stop.
Test the spring limit switch stops by moving the gate manually until you hear a click, making sure
contact is made with the spring limit switch on the motor.
Spring limit switch
Spring limit switch
