GA600AC Sliding Gate Opener User Manual
26
You can still control the opening and closing, but there is no feedback on the app after
opened or closed.
It is suggested to use this WIFI control under your visible sight of the gate to avoid
damage to persons or properties.
For specific operation teaching, please refer to the video 1(overall operation), video
2(record the travel time) and video 3(operation after adjustment)
Maintenance
The gate should be checked every month to make sure it operates normally.
For the sake of safety, each gate is suggested to be equipped with infrared protector, and
regular inspection is required.
Before installation and operation of the gate opener, please read all instructions carefully.
Our company keep the right to change the instruction without prior notice.
Troubleshooting
Any troubleshooting work below done to the motor must be completed by a licensed
electrician and only whilst the power is off and the motor is unplugged!
Problem
Possible Reason
Solution
The gate cannot open
or close normally, and
LED does not light.
1. The power supply is
disconnected.
2. Fuse is blown.
3. Control board X1 terminal
wrongly wired.
1. Connect the power supply.
2. Check the fuse (FU) and replace if
blown.
3. Re-wiring according to user
manual.
The gate can only
open, but cannot
close.
1. Photocell wrongly wired.
2. Photocell wrongly
installed.
3. Photocell is blocked by
objects.
1. If not connect photocell, please
ensure the infrared port and GND port
has a jumper wire; if connect photocell,
please ensure the wiring is correct and
the photocell status is N.C.
