Gateway 910 Series, Системное руководство

Страница: 96 / 129

88
Troubleshooting
Diskette drive reset failed Open the BIOS Setup utility, then make sure
the drive settings are correct.
Check the diskette drive cables. Make sure
Pin 1 on the cable aligns with Pin 1 on the
connector.
Diskette read failed - press F
1
to retry boot
Make sure the boot disk contains the
Command.com file.
Use the BIOS Setup utility (if necessary) to
make sure your drive or controller is configured
correctly.
Press
F1
to restart the server.
Gate A20 failure You may have an XT keyboard connected to
an AT server or vice versa. Make sure the
keyboard is configured to work with the
appropriate server. Some keyboards have a
switch to select either AT or XT.
Hard disk controller failure Make sure the hard drive cable is properly
connected.
Open the BIOS Setup utility, then make sure
that the correct drive type is selected.
Hard disk controller failure -
press
F1
to try reboot
The drive controller may be defective. Press F1
to try to restart the server.
Try running Fdisk and DOS Format. For more
information, refer to your operating system
documentation.
Insert bootable media device See “The server does not recognize the IDE
drive” on page 76 for a possible solution.
Backup your files as soon as possible.
Insufficient disk space Check the free space on the diskette or drive.
If the diskette or drive is full or almost full,
remove unnecessary files.
Invalid configuration
information Open the BIOS Setup utility, then make sure
the settings are correct.
Error message Solutions