PF4K Setup
Page 12
Pull out controls on left side of Front Shell.
Housing controls on the front shell
must be retracted for camera clearance during insertion. Power, Menu and
Record/Back controls will retract. Refer to Section 3 Operation for more details on
the housing controls.
Place camera to housing.
Locate the Bridgeplate and the Dovetail receiver.
Connect the RS cable
from the Record Trigger to the camera RS port.
Insert Camera into housing.
Gently slide the camera on the Bridgeplate into the
housing until fully seated. The camera should move into the housing without
obstruction.
CAUTION: AVOID OBSTRUCTIONS.
The camera should insert freely, without
obstruction. If obstructions or resistance are encountered, stop. Remove the
camera, find the cause of the obstruction, and try again.
Lock the camera
into position with the locking lever.
Mate and Check Controls.
This is a good time to verify operation of all Mid Shell
controls. Push in on the left side and right side, confirming that the controls touch
and operate the associated camera function (see Section 3 Controls for more
information). Check all pushbuttons, too.
Pull out Power, Menu
and Record/Back
controls for camera
insertion clearance.
