PF4K Setup
Page 23
Housing Closure
General.
The Rear Shell slides from the rear onto the foot rails, over the camera
and mates with the Mid Shell. If there is obstruction at any time during this process
– stop! – remove the shell and locate the obstruction.
Install Trim Weights.
Trim weight on the bottom of the mid shell can only be
installed prior to closing the back shell.
See
Buoyancy Adjustment
in section 3 for
more details.
Retract controls.
The power on/off control will retract slightly.
Mate the shell.
Position the shell at the rear and gently move forward over the
camera to mate with the Front Shell.
CAUTION: AVOID OBSTRUCTIONS.
The Rear Shell should insert freely,
without obstruction. If obstructions or resistance are encountered,
stop. Remove the camera, find the cause of the obstruction, and try
again.
Mate the Rear Shell to the Mid Shell.
The Foot Rails will guide them together.
