Gatekeeper Systems Fleet Safety, Security and Tracking Solutions G4-304SD1, Руководство пользователя и инструкция по установке

Страница: 145 / 149

G4-304SD1 User Manual & Install Guide
145 of 149
9.4 Camera Mounting and Connections
General Considerations

Camera mounting locations are to be determined by the customer/client.

Cameras should be mounted to the ceiling whenever possible. Install the rubber pad provided
with each camera and cut a small notch in the rubber pad to accommodate the camera cable.
The audio hole on the front of the camera can be used as an aiming guide for the direction the
camera needs to be facing.

All camera harnesses must be carefully routed to the G4-304SD1 unit to avoid pinching or
piercing the shielded camera cable.

All cables running through holes in sheet metal (ceiling, bulkhead, etc) must be protected with
grommets.

Ensure included gasket is in place between dome base plate and mounting surface.
When installing multiple cameras, mark camera harness wires so the school district knows which
camera is front and back by looking at the marked Molex output connectors.
Important Notes
Routing the Camera Harness (GSWHC2N-XX):

Always use grommets when running the harness through sheet
metal holes.

Avoid excessively tight bends especially around metal surfaces.

Coil and tie off excess harness in a safe place.
DO NOT disassemble the Camera Ball unless directed to, and
under the supervision of an authorised Gatekeeper Systems
support technician.
Camera Body Parts
A : Rubber Gasket
B : Base Plate
B1 : Cut Out Notches
C : Camera Ball
D : Camera Collar
E : Retainer Ring