EN
72
9. Empty and rinse all parts of the juicing system immediately after juicing. Then
clean all used parts (see: ‘Care and Cleaning / Thorough Cleaning of the Jui-
cing System’).
NOTE
You should not store juices and pulp in the containers of the appliance to avoid
that food dries on the surfaces. Additionally, some food may cause discolourati-
on. For storage, fill the products into sufficient containers and clean the containers
of the appliance immediately after usage. Pulp and juices may be stored in the
refrigerator for 1 day at the maximum. However, for always getting the optimum
benefits of vitamins and other valuable nutrients, it is best to always freshly prepare
and consume your juices.
USING REVERSE OPERATION
CAUTION
– If any extremely hard, sharp-edged parts of the food (e.g.
pieces of stones) get clamped between the filter sleeve and squeezing auger, you
need to remove and disassemble the juicing system for removing the obstacle (see:
‘Care and Cleaning / Disassembling the Juicing System’). Do not attempt to get
this type of obstacle out via reverse operation to avoid damage to the filter sleeve
and squeezing auger.
When you are processing very juicy ingredients or the squeezing auger and filter
sleeve get blocked by tough fibres of the ingredients, it might be useful to intermedi-
ately and repeatedly try reverse operation for a short time (see: ‘Properties of Your
New Juicer / Power Switch for Forward and Reverse Operation’).
1. Switch to the central position“O” for stopping the motor. Then switch to the low-
er reverse position (“R”). You need to hold the reverse position pressed as long
as the motor shall run in reverse operation, because in this position the power
switch will spring back.
2. Let the motor operate, until the ingredients are moved up. Then, release the
power switch. Switch to the upper forward position (“I”) again.
3. When the juicer runs again as usual, you may continue juicing by filling in the
next pieces of food. Otherwise, try again by repeating steps 1 and 2.
IMPORTANT -
If this procedure is not successful, you need to remove the complete
juicing system for clearing away the obstacle, before you can continue operation
(see: ‘Care and Cleaning / Disassembling the Juicing System’).