9
8
Heater Positioning
NOTE: If heater is being left unattended when not in
use, it is highly recommended the floor bracket be used
and the heater be firmly secured to the floor. Always
ensure the correct fastener is used for the type of floor
the bracket is being attached to, if unsure discuss with
your local hardware store, refer to page 8 for details of
securing.
1. Only use heater on flat, level, solid ground.
2. Position heater at least 300mm from the eave lining
or ceiling.
3. Only use heater on the stand provided.
4. Only use heater when fully assembled and with the
SUPPLIED water or sand containers full.
5. Never position in front, above or below a power
point.
6. If heater is facing another vertical surface, example –
wall, the gap must be at least 1 metre.
7. Never mount heater within 1 metre of a water source,
example – tap, pool, spa or water feature.
8. Never mount heater into the wall or ceiling. Only
mount to the stand provided.
Controls, Built In & Remote
Once the heater has been turned on at the heater head,
this heater can then be operated either by the provided
remote control or by the built in controls in the heater
head. The operating controls, Remote/Built in, are the
same.
To use the remote control;
- Slide back off the remote control
- Insert 2 x “AAA” batteries (Not Supplied)
- Slide the back into position.
Using Heater, FIG E
Position heater and ensure that the screw feet are
against the ground and that the heater is stable.
1. Plug into 240V AC wall socket and turn ON.
Note: All outdoor power points must be installed by
a qualified electrician and should be of a waterproof
style.
2. Press Main Switch ”-” on the heater head, the digital
display will start flashing showing that the heater is
on standby.
a. The heater can now either be operated with the
remote control or the built in heater controls.
3. Heater Controls
a. Press “Mode” button to turn heater on. By
pressing the “Mode” button again you will change
the heater setting.
i. This will cycle through each heat setting
continually with each press of the “Mode”
button.
ii. The selected setting will display on the built in
display on the heater head
b. Press “Timer” button to choose the length of time
the heater will operate before turning off.
i. The timer can be set between 0-9 hours.
1.“0” means the timer is off.
c. The digits of the power settings and timer will be
displayed as cycled: power settings for ten
seconds, timer flashing for five seconds.
4. Press button to switch on/off the Bluetooth
speaker.
5. Press “Light” button to switch on/off the LED light.
6. To shift the heater to standby mode, press OFF
button. The display will start flashing ”-” .
7. To switch off the heater, press Main Switch on the
heater head accordingly.
Bluetooth Pairing
To pair heater speaker with your Bluetooth compatible
music player/phone;
1. Press and hold button until you hear a
chime sound
2. Search for “HH-LY01” on your device.
3. Select and follow the prompts for pairing.
OFF
MODE
HEAT
TIMER
LIGHT
TIMER
LIGHT
MODE
OFF
27
28
FIG E
