7
6
11
19
16
20
11
22
11
26
23
FIG C
Heater Base, FIG C
3. Lay the Base Cover (#16) on its side with the cut out
visible and to the left.
4. Slide the power cord and assembled tubes (#19),
through the Base Cover (#16) carefully. Make sure
the power cord and Male Cord Connector (#23) are
not damaged when getting through the hole on the
Base Cover (#16). Fix the Lower Tube (#19) onto the
Junction Board (#26), which is pre-installed on the
top of the Base Cover (#16) with 4 Screws M6*12
(#11).
5. Detach the Junction Board (#26) from the Base Cover
(#16) by unscrewing and removing the 4 Screws M6*12
(#11), now slide the Base Cover up the assembled
poles so that you can access the bottom bracket on the
Lower Tube (#19). Use caution when sliding the base
cover, as you do not want to scratch the assembled
poles, suggest 1 person lift the assembled poles slightly
while the other person slides the base cover.
6. Screw the Lower Tube (#19) onto the Base (#20)
using 4 Screws M6*12 (#11) and Spring Washers M6
(#22).
7. Carefully slide the base cover down so that it is at the
base, do not trap the power cord or connector.
