5
4
ACCESSORIES
Accessory Name
Qty
Spring Hook
1
Screws M6*12
10
Water Tank
4
Spring Washer M6
4
Foot
4
Remote Control
1
Floor Bracket Mount
1
Floor Bracket
1
Floor Bracket Concrete
Expansion Bolt
1
Note: Remove all transit packaging and protection
material before starting to assemble. Dispose of in
an environmentally friendly way
.
Note: In order not to damage or scratch parts/components
it is recommended that a blanket is place on the ground
before unpacking this heater. Given the size and weight of
this heater it is recommended that 2 people are required
for assembly.
Note: Only tool required is a “Phillips” cross head screw
driver.
Heater Head and Stand, FIG A
To avoid scratching lay parts/components on a blanket
for assembly.
1. Hook the Carbineer (#3) onto both the top of the
Heater Bracket Plate (#18) & Heater Steel Plate (#32).
2. Put Cord Bushing (#7) & Tube Cover (#6) onto the
open end of the Upper Tube (#8).
3. Pull the excess power cord between the Heater
Head (#1) & Upper Tube (#8) into the other tubes.
Do not make too tight, have enough excess cord
to be able to put your fingers between the excess
cord and the spring extension (#3) this will ensure
that the Heater Head (#1) is free to move when you
stand it up.
4. Secure power cord into clamp on Heater Steel
Plate (#32).
5. Fix the Curved Tube (#12) to the Upper Tube
assembly, using the Tube Connector (#10)
& Screws M6*12 (#11).
6. Fix the Middle Tube (#14) to the Curved Tube
assembly, using the Tube Connector (#10)
& Screws M6*12 (#11).
7. Fix the Lower Tube (#19) to the Middle Tube
assembly using the Upper Rotary Tube Connector
(#13) & Screws M6*12 (#11) & Screw Knob M6*16
(#18).
ASSEMBLY INSTRUCTIONS
6
7 32
8
1
3
18
11
12
11
13
11
33
11
10
10
19
14
FIG A
