Gartner BCG-3014, Инструкция по эксплуатации

Страница: 31 / 56

31
Fig. 9 Fig. 10 Fig. 11
On the control handle set the ignition 14 into the position "ON”.
On the control handle press the throttle trigger 17 and lock it with the throttle trigger stopper 16.
Hold the brush cutter with one hand and with the free hand pull the starter grip to its "mesh". Pull the
starter grip several times without jerk (fig. 10) till the first engine start.
WARNING! Strong jerks of the cord, as well as pulling the cord until it stops, can
damage the starter mechanism.
Set the choke lever to the center position (fig. 11).
Pull the starter grip several times until the engine starts. Allow the engine to warm up for 5-10
seconds.
Move the choke lever down, then pull the trigger stopper to release the throttle.
Gently press the throttle trigger, bring the engine up to the required speed and start working. Do
mowing, firmly holding the product by ergonomic handle with both hands.
To start a warm engine, follow the same procedure as for a cold start, but without pressing the pump.
The choke should be in the lower position.
WARNING! The product is equipped with a semi-automatic string supply system.
During the product operation at maximum rpm flip the trimmer spool onto the ground,
the length of the cutting string will increase by about 30 millimeters.
4.2 Stopping the Product Engine
Release the throttle trigger. The engine should cool down a bit, working at idle.
Turn the ignition switch in the direction of the arrow shown on the control handle to the position
«STOP».
WARNING! After working out the fuel mixture from the fuel tank the engine must be
cooled before refueling.
After finishing work the unused fuel mixture may remain in the fuel tank. Be sure to pour it out into the
canister. It is not allowed to leave the fuel mixture in the brush cutter tank for more than 12 hours. This
can lead to unstable operation of the engine.
WARNING! Use only the trimmer string recommended by the manufacturer. String
diameter must not exceed 3 mm.
4.3 Working with brush cutter
WARNING! When using the product, to prevent the possibility of injuries from the
objects flying out of the working body, always wear safety glasses, gloves and sturdy
shoes.
Before mowing, carefully inspect the work area and free it from foreign objects, including broken glass,
pieces of wire, rebar, stones and similar objects, as they may cause damage or injury to the user and
others.
Do not overload the engine of the product. Mow the grass with the tips of the trimmer string as mowing
with the entire length of the string reduces the efficiency of the product and may overload the engine.