12
EN
DIP Switch settings
Wallbox enabled via
SW1 (DIP 4)
Open contact
ON (Factory setting)
Closed contact
OFF
Remote enable function
An external relay can be connected to the Remote control
terminals to remotely enable the wallbox.
Dip 4: Remote control -
see table below
External charge control:
open contact=enabled,
closed contact=disabled
*Remote control signal can
be set in inverse function.
• The wallbox can be enabled in two ways:
• Enable charging by opening the circuit between the Remote
Control connection blocks. This option is the factory setting.
• Enable charging by closing the circuit between the Remote
Control connection blocks.
(figure 1)
OFF
4
ON
SW1
4
OFF
4
ON
Remote control
Assembly instructions
