Enabling Some Engine Gauge Status Alarms
1 From the engine gauges screen, select Menu > Gauge Setup > Status Alarms > Custom.
2 Select one or more engine gauge alarms to turn on or off.
Setting the Fuel Alarm
CAUTION
The Beeper setting must be turned on to make alarms audible (
). Failure to set
audible alarms could lead to injury or property damage.
Before you can set a fuel level alarm, you must connect a compatible fuel flow sensor to the chartplotter.
You can set an alarm to sound when the total amount of remaining onboard fuel reaches the level you specify.
1 Select Settings > Alarms > Fuel > Fuel Alarm > On.
2 Enter the remaining amount of fuel that triggers the alarm, and select Done.
Setting the Fuel Capacity of the Vessel
1 Select Settings > My Vessel > Fuel Capacity.
2 Enter the combined total capacity of the fuel tanks.
Synchronizing the Fuel Data with the Actual Vessel Fuel
You can synchronize the fuel levels in the chartplotter with the actual fuel in the vessel when you add fuel to
your vessel.
1 Select Gauges > Engine > Menu.
2 Select an option:
• After you have filled up all the fuel tanks on the vessel, select Fill Up All Tanks. The fuel level is reset to
maximum capacity.
• After you have added less than a full tank of fuel, select Add Fuel to Boat, and enter the amount added.
• To specify the total fuel in the vessel tanks, select Set Total Fuel Onboard, and enter the total amount of
fuel in the tanks.
Viewing the Wind Gauges
Before you can view wind information, you must have a wind sensor connected to the chartplotter.
Select Gauges > Wind.
Configuring the Sailing Wind Gauge
You can configure the sailing wind gauge to show true or apparent wind speed and angle.
1 From the wind gauge, select Menu > Sailing Wind Gauge.
2 Select an option:
• To show true or apparent wind angle, select Needle, and select an option.
• To show true or apparent wind speed, select Wind Speed, and select an option.
Configuring the Speed Source
You can specify whether the vessel speed data displayed on the gauge and used for wind calculations is based
on water speed or GPS speed.
1 From the wind gauge, select Menu > Compass Gauge > Speed Display.
2 Select an option:
• To calculate the vessel speed based on data from the water-speed sensor, select Water Speed.
• To calculate the vessel speed based on GPS data, select GPS Speed.
Gauges and Graphs
83
