![background image](http://html1.mh-extra.com/html/garland/enodis-gd-152h/enodis-gd-152h_installation-operating-and-service-instructions_3631431005.webp)
Part # 4519762 (01/05)
Page 5
INSTALLATION
General
1. Carefully remove unit from carton or crate. Burner
tie wires and other packing material should be
removed from units. On stainless steel units, the
protective material covering the stainless steel
should be removed immediately after the unit is
installed.
2. Remove top grates and place in a safe area to prevent
damage.
3. Should it be necessary to remove the steel griddle
plate on units equipped with griddle thermostats,
the griddle thermostat bulb and capillary must
first be withdrawn from the bulb shield assembly,
located on the underside of the griddle plate. This
can be accomplished with the griddle front raised
and supported by the griddle prop located on the
underside of the griddle plate. Loosen the four pal
nuts securing the bulb shield assembly to the griddle
plate and withdraw the griddle thermostat bulb.
4. When a griddle plate is being installed on units
equipped with griddle thermostats, the thermostat
bulb must be inserted in the groove between the
plate and the bulb shield assembly. This can be
accomplished with the griddle front raised and
supported by the griddle prop, located on the
underside of the griddle plate. It is important for
accurate temperature control that the bulb be
located inside the groove. Tighten the four pal nuts
securing the bulb shield assembly to the griddle
plate.
5. These units must be installed under an adequate
ventilation system. Refer to section titled Ventilation
for further instructions.
6. All burner adjustments and setting shall be made
by a qualified gas technician.
Clearances
MINIMUM INSTALLATION CLEARANCES TO
ADJACENT COMBUSTIBLE/NON-COMBUSTABLE
WALLS OR BASE
Model #
Sides & Back
Floor Or
Base
Combustible
Non
Combustible
GD-
152H(J)(FF),
GD-
302H(J)(FF),
GD-
304H(J)(FF)
6”
(152mm)
0”
Combustible
GD-15F(J)
6”
(152mm)
0”
Non
Combustible
GD-15G(J)(FF),
GD-25G(J)(FF),
GD-36G(J)(FF),
GD-15GTH(J),
GD-24GTH(J),
GD-36GTH(J)
6”
(152mm)
0”
Combustible
FOR INSTALLATION IN NON COMBUSTIBLE
LOCATIONS ONLY
GD-18RB(J)(FF),
GD-24RB(J)(FF),
GD-30RB(J)(FF),
GD-36RB(J)(FF)
N/A
0”
Non
Combustible
Gas Connections
1. The installation and connection must comply with
local codes, or in the absence of local codes, with
CAN/CGA-B149 Installation Code or with the
national Fuel Gas Code, ANSI Z223.1/NFPA No.
54 – Latest Edition.
Содержание Enodis GD-152H
Страница 13: ...Part 4519762 01 05 Page 13 NOTES...
Страница 14: ...Part 4519762 01 05 Page 14 NOTES...
Страница 15: ...Part 4519762 01 05 Page 15 NOTES...
Страница 16: ......