Gardsman CTC-1052RV, Руководство пользователя

Страница: 8 / 39

5
<
<
N
N
O
O
T
T
E
E
>
>
)
It is prohibited to learn in another or
the same Pedant twice, unless the
previously learnt-in pendant is
removed first.
Step 6. Otherwise, press both RESET &
HELP buttons at the same time to exit
Learning Mode. Or, CTC-1052RV will
exit Learning mode automatically after
5 mins of inactivity. CTC-1052RV‘s
Red LED will dim to indicate the
system is back to Idle mode.
2.2. Learning Pendant #2
For learning Pendant #2, please follow the
learning steps described in 2.1 Learning
Pendant #1. But the
RESET button decribed in
2.1 should be replced by the HELP Button.
2.3. Remove Pendant #1 & #2
CTC-1052RV can be programmed to remove
previous learnt devices by Command 80 or
81/82.
3. System Configuration
3.1. Entering Programming
Mode
Two CTC-1052RV programming modes are
available: Local Programming Mode and
Remote Programming Mode.
< < N N O O T T E E > >
)
GPRS/GSM will be powered down
when in Programming Mode. When
AC Power resumes or when exits from
Programming Mode, GPRS/GSM will
be powered on again.
3.1.1. Local Programming Mode
(Optional)
From Idle mode, follow the steps below to
enter Local Programming mode.
Step 1. Plug in the telephone set into
LOCAL PROGRAMMING input
located on the rear side of CTC-
1052RV.
Step 2. Pick up the handset.
RED LED lights up.
Step 3. Enter default ACCESS CODE, 1111
followed by # .
Step 4. CTC-1052RV will emit 2 short beeps
and the red LED starts to flash,
indicating it is in
Programming Mode.
Step 5. Proceed to program system by
referring to the Commands in section
3.2 Programming Your 1052 .
<
<
N
N
O
O
T
T
E
E
>
>
)
Local programming is prohibited when
AC Power fails.
)
The first digit of Access Code must be
entered within 15 seconds, otherwise
CTC-1052RV will exit automatically.
)
Failure to enter the correct Access
Code within 2 minutes will cause
CTC-1052RV to exit the Programming
mode automatically.
)
To exit Programming mode, enter 99
followed by # , or place the handset
on hook, or disconnect the
Programming telephone set.