23
GPRS Reporting Method
z
It is required to use SMS Remote
Programming to set Access Point
Name, IP Address, Port Number,
GPRS/IP Account Number, User
Name, and Password before GPRS
Reporting Method becomes effective.
z
Access Point Name (APN):
the
name of an access point for GPRS.
Please inquire your SIM card service
provider for your APN.
z
IP Address:
Central Monitoring
Station server IP
z
Port Number:
Central Monitoring
Station server port number
z
GPRS/IP Account Number:
your
account number, as set in Digital
Reporting Method (refer to section
3.2.
Programming Your 1052: Command
10-14
)
z
User Name:
offered by your SIM card
service provider.
Please inquire your
service provider for your GPRS
username. If no username is required,
you may skip this step.
z
Password:
offered by your SIM card
service provider.
Please inquire your
service provider for your GPRS
password. If no Password is required,
you may skip this step.
z
To disable GPRS Reporting Method:
by removing the IP address, GPRS
reporting becomes ineffective.
Proceed to SMS Remote
Programming and send in this format:
“
PROG 1111 TCIP1:
”
Where:
PROG
= SMS Keyword
1111
= Access Code
TCIP1
= SMS command for IP Address (no
input value means deletion of characters)
Digital Reporting Method
After the alarm reporting is successfully
received by the Monitoring Center, CTC-
1052RV will then follow the choice of
Command #38, to enter
Follow-On and/or
Call-Back
mode.
z
Call-Back Operation
z
If Command #38 is set as Call-Back
(1)
or Follow-On & Call-Back
(2)
, after
alarm is reported to CMS, the system
will then wait 5 mins for Monitoring
Center Personnel to call-back after
reporting.
z
If an alarm is successfully reported,
after the Monitoring Center calls back
within this 5-minute period, CTC-
1052RV auto-answers the call after
the 1st -2nd ring and waits for proper
Access Code (default is
1111)
entry
followed by the (
#
) key within 15 secs.
Please enter Access Code in normal
operation speed.
z
Upon the correct Access Code
received, CTC-1052RV will then open
a Full-Duplex Communication to allow
the Call Recipient to speak to CTC-
1052RV/WTRV/WTRVS directly. You
can also use the following DTMF
command to switch the speech mode.
Enter
(1)
to
TALK ONLY
Enter
(2)
to open
TWO-WAY VOICE
COMMUNICATION
Enter
(3)
to
LISTEN-IN ONLY
End a Call: enter (
9
) to
HANG UP or
put the handset back into the base
cradle.
Enter
(7)
to Speaker Volume Control
and then press
(6)
or
(4)
to increase
or decrease levels of speaker volume
in the “Two-Way” and “Talk Only”
communication modes.
Enter (8) to Microphone Sensitivity
Control and then press (6) or (4) to
increase or decrease levels of
microphone sensitivity in the “Two-
Way” communication mode.
Press any DTMF key,
except the
designed “hang-up” key (9), to add
another preset communication time.
Please note that when a particular
DTMF key is pressed, its designed
shortcut function will be executed &
the communication time will be
extended at the same time.
<
<
N
N
O
O
T
T
E
E
>
>
)
Please note that if you wish to enable a
Содержание CTC-1052RV
Страница 1: ...E1 MAR 30 2011...
