Gardner Denver Reavell H5000 Series, Руководство оператора

Страница: 81 / 96

ANCILLARY PARTS
PAGE 79
13 ANCILLARY PARTS
13.1 TEMPERATURE CONTROLLER – APP090
THERMOMETER SWITCHES
C202556, C202749, C202960 & C202964
98288.1093, 98288.1094 & 98288.1215
THESE THERMOMETER SWITCHES ARE SET TO THE FIGURES QUOTED BELOW, THE FOLLOWING
INFORMATION IS FOR SETTING INFORMATION ONLY, IF THE TEMPERATURE SWITCH HAS TO BE
REPLACED OR RE-ADJUSTED.
IF THE SWITCH NEEDS TO BE RE-ADJUSTED DUE TO A HIGHER AMBIENT TEMPERATURE OR ANY
REASONS PLEASE CONTACT COMPAIR UK LTD. IPSWICH FOR MORE INFORMATION.
B
C
D
A
TO SET TRIP INDICATOR POINTER.
RUN COMPRESSOR TO ESTABLISH NORMAL RUNNING TEMPERATURE OF BLACK POINTER [A].
WHEN READING IS STABLE, REMOVE ADJUSTING KEY [B] FROM REAR OF SWITCH AND INSERT
INTO FRONT OF CENTRAL KNOB ADJUSTER [C].
ROTATE KEY TO ADJUST RED POINTER [D] TO 10°C ABOVE RUNNING TEMPERATURE POINTER
[A].
ADJUSTMENT OF TRIP POINTER MUST BE WITHIN RANGE THAT HAS BEEN PRE-SET AT COMPAIR
BEFORE DESPATCH, BUT MAY BE ADJUSTED WITHIN THIS RANGE DEPENDING ON AMBIENT
CONDITIONS.
NOTE: DO NOT RESET TEMPERATURE CONTROLLER SETTING IF IT TRIPS, ALWAYS LOCATE AND
CORRECT POSSIBLE FAULT BEFORE ANY ATTEMPT IS MADE TO ALTER SETTING.
CONTACT CompAir UK Ltd IPSWICH ENGINEERING DEPARTMENT FOR MORE INFORMATION IF THE
COMPRESSOR TRIPS WHEN SWITCH IS SET AT MAXIMUM VALUE.