Gardner Denver Elmo Rietschle G Series, Руководство по эксплуатации

Страница: 22 / 44

5
Installation
610.44434.40.000 · 08.2019
22 / 44
© Gardner Denver Deutschland GmbH
Mounting
The following installation positions are permitted by the manufacturer:
Type Without spring ele-
ments
With spring elements
Item 5210, [
➙
15] Item 5212, [
➙
15]
2BH1/9 with drive control
1/2
2BH11.. – 2BH18..
1/2
2BH19..
(without 2BH1943)
1/2
2BH1943
2
2BH923..
1/2
1
Not a function of the condensate drain hole L12
2
Conveying moisture and condensate along with the other material reduces the
service life of the rolling bearings
Level assembly on the foot
1. Mark the fixing points through the holes in the foot (item 0062, [
➙
14]) or by
referring to the dimensional drawing.
2. Lift the G-BH1 | G-BH9 away and drill the holes for the fixing points.
3. Place the G-BH1 | G-BH9 with the foot in assembly position.
4. Screw the foot to all anchorage holes with fastening elements.
 M8 steel (8.8 according to ISO 898-1): 18 – 22 Nm (13.3 – 16.2 ft lbs)
 M10 steel (8.8 according to ISO 898-1): 35 – 42 Nm (25.8 – 31.0 ft lbs)

M12 steel (8.8 according to ISO 898-1): 58 – 70 Nm (42.8 – 51.6 ft lbs)
Vertical mounting on the compressor cover
!
Spring elements (item 5212, [
➙
15]) must be used in order to mount vertically
on the compressor cover (item 0030, [
➙
14]).
1. Mark the threaded holes for the cover position (item N8.8, [
➙
14]) based on
the dimensional drawing.
2. Drill the holes for the fixing points.
3. Screw the threaded studs of the spring elements into the threaded holes for
the cover position.
CAUTION! Tighten securely! Tightening torque 11 - 22 Nm (8.1 - 16.2
ft lbs)
4. Place the lifting strap around the motor (item 0001, [
➙
14]) between the com-
pressor housing (item 0002, [
➙
14]) and the sleeve.
5. Lift the G-BH1 | G-BH9 and tilt it with two people onto the compressor cover.
6. Place the G-BH1 | G-BH9 with the compressor cover in the assembly posi-
tion.
7. Screw the G-BH1 | G-BH9 to the mounting surface using the threaded hole in
the spring elements and securing elements.
 M12 steel (8.8 according to ISO 898-1): 58 – 70 Nm (42.8 – 51.6 ft lbs)
8. Remove the lifting device.
5.4
5.4.1
5.4.2