37- 1- 613 Page 36
SECTION 6
DISASSEMBLY INSTRUCTIONS
FIGURE 6- 1 – ADAPTOR PLATE
FIGURE 6- 2 – BEARING PRESS PLATE
Illustrations for Disassembly Instruc-
tions are taken from various sizes of
CycloBlower. Minor variations in
construction of some parts need
cause no concern.
1.
Provide adaptor plate, FIGURE6 - 1, for pulling
the
gear hub and pinion gear. Pulling directly on
pinion teeth will damage teeth making timing
difficult and will cause gear wear. Pulling directly
on the gear hub flange will distort the flange
causing gear run- out. The adaptor plates shown
are designed for a jaw type hydraulic puller,
FIGURE6-4 and FIGURE6-5.
Other type pullers are available, and if used, suit-
able adaptor plates should be provided.
2.
Provide bearing press plate, FIGURE6-2, for
pressing out rotors and installing bearings.
FIGURE 6- 3
–
SPANNER WRENCH
FIGURE 6- 4
Содержание 5CDL-R Series
Страница 14: ...37 1 613 Page 13 FIGURE 2 3 BELT DRIVE OVERHUNG LOAD CALCULATIONS...
Страница 17: ...37 1 613 Page 16 TOP INLET MAIN ROTOR DRIVE FIGURE 2 4 OUTLINE DIMENSIONS...
Страница 30: ...37 1 613 Page 29 SECTION 5 PARTS LIST FOR LIST OF PARTS SEE PAGES 30 31 301CBH810 00 Ref Drawing...
Страница 40: ...37 1 613 Page 39 FIGURE 6 10 FIGURE 6 11 JACK SCREWS...