Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
29
Feeding the line
The line trimmer has a bump feed mechanism which releases the line
without having to stop the engine.
1. To release additional line increase the speed of the motor to no less than
half speed, then, lightly tap the bump knob (34) on the ground while
operating the unit at high speed.
NOTE:
Always keep the line fully extended for optimum cutting
performance. Line release becomes more difficult as the cutting line
becomes shorter. Cutting efficiency also decreases as the line
becomes shorter.
The line will not extend if the speed of the spool is not operating at least
half speed. If the line does not extend, increase the speed to full speed while
tapping the bump knob on the ground. If the line still does not extend, stop
the motor and check the line inside the spool has not tangled and
also ensure there is sufficient line in the spool.
2. Each time the head is bumped it releases approximately 2cm of line.
Release the line until it strikes the cut off knife (32). This may require
several taps.
NOTE:
The cut off knife (32) on the clip-on line trimmer guard attachment (33)
will automatically cut off any excess line. For best results tap the head on hard
soil or bare ground. Never bump the spool head on concrete as it may crack the
spool housing. Make sure the cut off knife (32) protector has been removed.
It is recommended to replace the protector when the line trimmer is not in use.
IMPORTANT.
Do not hit stones (even small ones), piles of earth, and small
pieces of wood or anything else that could be hidden or poorly visible in the
grass. If you hit a large object by accident, or if you jam the cutting tool due
to overloading or having the cutter jammed with grass, you must stop the
engine.
NOTE:
All protective devices of the machine as well as protective equipment
must be maintained in good operation condition during the period of use.
NOTE:
If the line is too short you may not be able to advance the line by
tapping it on the ground. If this is the case, stop the engine and manually
advance the line.
