Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
12
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
Operation of the Brushcutter / Line Trimmer
Adding and Checking the oil
IMPORTANT:
The motor of this brushcutter / line trimmer is packed with NO
OIL in the motor. Prior to starting the motor, oil MUST be added to the oil
reservoir (24). Failure to add sufficient oil will result in damage to the motor
which is NOT covered under the warranty of the unit.
NOTE:
This is a 4 stroke brushcutter / line trimmer. The motor sump MUST
be filled with 60mL of SAE 10W/30 BEFORE starting. Fresh unleaded fuel
must be used in this unit. Do not use ethanol based fuels.
Do NOT mix oil with fuel. Oil must be separately poured into the sump of
the motor as follows, and also the oil level MUST be checked every time the
line trimmer / brushcutter is used.
NEVER
attempt to remove the oil dipstick (24) while the motor is running.
ENSURE the motor is not running when the oil level is being checked.
On a new unit, the motor needs to be filled with 60mL of SAE 10W/30
engine oil.
To initially fill with oil or to check the oil level,
follow the process below.
1. Lay the unit down so that the fuel tank bracket
(38) is resting on a secure surface, or on the
ground. Clean the area directly around the
oil reservoir (24). (Fig. A)
2. Clean the area directly around the oil dipstick
(24), and then fully remove/unthread the oil
dipstick in an anti clockwise direction.
3. On a new unit which has not previously been
filled with oil, Measure 60mL of SAE 10W/30 oil
and pour into the oil reservoir (24) where the
dipstick was removed.
4. Clean the dipstick portion of any oil residue
and then insert the dipstick fully into the motor,
however, DO NOT THREAD the dipstick into the
reservoir. Hold the dipstick in place for a few
second and then remove. (Fig B)
A.
B.
