Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
15
Connecting the J handle to the Upper shaft
WARNING. The J handle must be fitted before use of this product.
This includes both combinations of the Brushcutter or the
Line Trimmer. Ensure the motor is NOT operating when fitting
or adjusting the J handle.
1. Lay the unit down so that the fuel tank bracket (38)
is resting on a secure surface, or on the ground.
The J Handle clamp assembly has already been
located and fitted to the upper shaft (15).
Using the supplied 5mm allen key (36), and the
10mm open ended spanner (36), remove the
screws retaining the top clamp plate of the clamp
assembly. Remove the top clamp plate. (Fig I)
NOTE:
The two screws retaining the top cover
plate are of a different length and MUST be
replaced in the same position. The longer screw
is the 10mm Hex headed bolt. (Fig J)
2. The J handle (12) will sit in the recess of the
J handle clamp, but the locating screw in the
recess must locate in one of three holes in the
J Handle tube i.e select the length of the J handle
required and locate the J handle in the clamp
recess with the locating screw entering one of the
three holes in the J handle tube. (Fig K & L)
L .
K .
I.
Hex head
screw
J.
Hex head
screw
