Gardenline 06/14, Руководство пользователя

Страница: 19 / 37

18
www.coreservice.co.uk AFTER SALES SUPPORT
IRE GB
0845 872 2740
019022605 GPCS46Z, 06/14, 52579
Operating Instructions
7
Operation
Starting the engine
1. Fill the fuel and chain oil tanks respectively, and tighten the
caps securely. (FIG 12)
2. Engage the chain-brake (push it forward until an audible click
is heard).
3. Set the switch to the “START” position. (FIG 13)
4. Press and release the primer bulb(5) 10 times and ensure that
the primer bulb is approximately 3/4 filled with fuel before
attempting to start. (FIG 14)
5. Pull the choke control out to engage. (FIG 14)
6. While holding the saw unit securely on the ground, pull the
start handle two times. at this point, the engine will usually
not start. (FIG 15)
WARNING: Do not start the engine whilst holding the
chainsaw in one hand. The saw chain may touch your body.
This is very dangerous.
7. Push the choke control in to disengage. (failure to do this may
cause the engine to flood)
8. Pull the start handle with smooth, continuous pulls no more
than five times . if the engine does not start, remove the spark
plug for 30 minutes, replace, and repeat the start procedure.
9. Allow the saw to run and warm up in this position for 30
seconds.
10. Disengage the chain-brake, by pulling it back.
Note: If you fail to start your machine, or require further
assistance, please contact our after sales support team, details can
be found at the bottom of the page.
Note: When restarting immediately after stopping the engine
or when the engine is warm, it will not be necessary to use the
choke function.
Make sure the cutting blade is pointing away from your body at
all times, the chain may rotate upon ignition.