Filling in chain oil:
0
q
w
DANGER!
Physical injury due to chain breakage when the chain
on the bar is not sufficiently lubricated.
v
Check whether sufficient quantities of chain oil are
delivered prior to each use.
We recommend to use
Art. 6006 GARDENA Oil or an equivalent
mineral chain oil from a specialist supplier.
1. Unscrew lid of oil tank
0
.
2. Fill chain oil into the filler neck
q
until the viewing window
w
is
fully filled with oil.
3. Close the lid of oil tank
0
again.
The device must be cleaned thoroughly if oil has been spilled.
Checking the oil lubrication
system:
v
Point the bar
e
at a bright wood cutting surface at a distance
of approx. 20 cm. After operating the machine for one minute,
clear traces of oil must be visible on the surface.
Never let the bar come into contact with sand or soil as this
will lead to increased wear of the chain.
5. Operation
Working positions:
The Pole Pruner can be operated in 2 working positions
(above/below). To ensure a tidy cutting edge, thick branches
should be cut in 2 steps (Illustrations similar).
max.
4m
ma
x.
4m
A
ß
ß
B
Above
(thick branches):
1. From below, saw the
branch to no more
than 1/3 of the dia meter
(chain will push towards
the stop at
the front
ß
A
).
Above
(thick branches):
2. Cut off the branch
from above (chain
will push towards the
stop at the back
ß
B
).
Below:
Cut off from above
(chain will push towards
the stop at the back
ß
B
).
20
GB
