8. Troubleshooting
w
DANGER! Risk of physical injury!
Cut injury when the Pole Pruner switches on
unintentionally.
v
Before performing troubleshooting work, remove
the battery (see 4. Initial Operation), and slide the
protective cover
w
onto the bar and close until the
snap fit engages.
Problem
Possible Cause
Remedy
Pole Pruner does not
start up
Battery is flat.
v
Charge battery
(see 4. Initial Operation).
Battery not pushed onto the
handle properly.
v
Push battery onto the
handle and make sure that
the locking buttons snaps
in correctly.
Chain blocked.
v
Remove blockage.
Low runtime
Chain tensioned excessively.
v
Tension chain
(see 7. Maintenance).
Chain not lubricated due to
lack of oil.
v
Refill oil
(see 4. Initial Operation).
Hedge is not cleanly cut
Chain dull or damaged.
v
Replace chain.
Pole Pruner cannot be
switched off
Start button is stuck.
v
Remove battery and loosen
start button.
Pole Pruner stops.
Error-LED
ß
W
flashes
Battery overload.
v
Wait for 10 sec.
Press button
ß
B
on the
battery and restart.
High temperature. The allowed
operation temperature was
exceded.
v
Leave battery to cool for
approx. 15 min.
Press button
ß
B
on the
battery and restart.
Charging indicator lamp
9
on
the charger does not light up
Battery charger or charging
cable not plugged in properly.
v
Plug in battery charger and
charging cable properly.
Charging control lamp
9
on the charger flashes rapidly
(twice per second)
Charging error.
v
Unplug charger and plug
in again.
Pole Pruner stops.
Error-LED
ß
W
is lit
Battery error /
battery defective.
v
Press button
ß
B
on the
battery and restart.
The battery can no longer
be charged
Battery is defective.
v
Replace the battery
(Art. 9840).
Only the original GARDENA Replacement Battery BLi 18 (Art. 9840) may be used.
This can be obtained from your GARDENA dealer or directly from GARDENA Service.
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
24
GB
