TR-RT LED lighting controllers - User Manual
2
Safety precautions
Read this before using the TR-RT. Always observe the following safety
precautions. If in doubt, contact Gardasoft Vision Ltd. The following
symbols are used in this guide:
Warning:
Read the instructions to understand the
possible hazards.
Warning:
Surface may get hot.
Warning:
Possible hazardous voltage.
Where these symbols appear in this guide, refer to the text for the
precautions you should take.
2.1
Heat
Ensure the TR-RT is mounted correctly (see
), and that you do not exceed any of the ratings for the unit (see
1.1, Specifications and ratings
)
At its maximum ratings, the TR-RT’s enclosure can exceed 65°C which is
sufficient to cause a burn if touched. Place in a position where personnel
cannot accidentally touch it and ensure there is a free flow of air around
the unit.
2.2
Electrical
The TR-RT produces high energy pulses. Take care to connect the outputs
correctly and protect the output wiring and load from any short-circuits.
When switched off, energy remains stored in the TR-RT for about 15
seconds.
The TR-RT does not have complete tracking isolation of input and output.
Transients caused by inductive loads must be supressed externally to the
TR-RT.
Warning:
This is a Class A product. Its use in residential areas may cause
radio interference, and such use should be avoided unless special
measures are taken by the user to restrict emissions to a level that allows
the reception of broadcast transmissions.
2.3
General
TheTR-RT must not be used in an application where its failure could be a
danger to personal health or damage to other equipment.
—
7
—
