4
2
Getting Started
Read the sections on Safety and Specifications and check the PP600 fulfils
your requirements. See inside the front cover for other Gardasoft Vision
lighting controllers.
Connect the PP600 up to a supply and an LED lighting unit as described in
“Connections.” Note that the supply voltage must be connected to three
terminals. When the PP600 powers up it should show two alternating lines on
the display to indicate that it is operating properly.
Read the section on “Operation” and use the Simple Set Up to make the PP600
supply a small continuous current to the LED unit. Check that the LED unit
illuminates.
Users who have a PP610 or PP612 should refer to the PP610 section and read
how to send RS232 commands.
Mount the PP600 as described in “Mechanical Fixing” using a DIN rail or the
mounting holes. In particular read the notes on heatsinking.
Set up the PP600 for the desired operation and test.
See the appendix on Application Notes for additional information on the use of
the PP600. Visit www.gardasoft.com for more Application Notes.
Throughout this manual, references to the PP600 refer to all variants in the
PP600 range unless otherwise stated. The symbol “us” is used to denote
microseconds.
