PixelMASTER GXi Series NVR
User’s Manual
05-2014-A
59
59
7.
REMOTE
7.1 WEB SERVER
NVR prepares the web server internally. This server consists of two services. One is for the remote
configuration of NVR setup and the other is for the client viewer based on the Active-X.
Using the remote configuration, you can configure all feature sets of NVR. And the live preview,
search and PTZ control can be served by the
‘WebViewer’.
The table below shows the recommended PC specification for the proper operation.
[Recommended Specification of PC
]
Recommended
Operating System
Windows 7
CPU
Core i5 @3.3GHz or Higher
Memory
2 GB
Video Card Memory
512MB
HDD Capacity
2GB
VGA Resolution
1920x1080x32
Direct-X
DirectX 9.0c
Network
Etheret 10/100B-TX
7.1.1 CONNECT TO WEB SERVER
Enter the IP address of NVR into the ULR bar referring to the below picture.
NOTE) You can know the IP address of NVR from the ‘INFO’ section under the
OPERATION
SETUP
of NVR menu. If the local IP which starts with ‘192.168.xxx.xxx’ is used in the NVR,
you have to set the ‘Port Forwarding’ properly in your router. The port number to set can
be get from ‘NVR PORT’ in the
NETWORK SETUP
. If your router supports the ‘uPNP’ feature,
there is no need to set ‘Port Forwarding’ manually because the NVR supports the ‘Auto
Port Forwarding’ function using the ‘uPNP’ protocol. (Some routers can make the
compatibility issues to the uPNP protocol of NVR)
NOTE) If the access to the web server can’t be established after setting the ‘Port
Forwarding’, you may need to check the firewall of router and your PC. The port used in
the NVR should be allowed to access by the firewall.
