G&D DL-DVI-Vision-IP Series, Инструкция по установке и эксплуатации

Страница: 127 / 228

Installation
8 · G&D DL-DVI-Vision-IP
Activate the generic USB mode (see (De)Activating an USB keyboard mode the »Generic
USB« mode on page 82) if you want to connect another USB input device or USB
mass storage device. In this mode, any data of the USB device is not altered when trans-
mitted to the computer module.
Mouse: Connect the PS/2 mouse of the console.
Keyb.: Connect the PS/2 keyboard of the console.
Connecting the console monitor
DVI-D DL Out:
Connect the console monitor.
Connecting audio and RS232 interfaces
Micro In:
If required, connect a microphone to this interface.
Speaker: Connect the speakers or another audio output device.
RS232:
Connect the serial end device to this interface.
IMPORTANT:
If the generic USB mode is active, the OSD cannot be operated by a
keyboard connected to the Generic socket.
IMPORTANT: This product allows simultaneous use of up to three GenericUSB
devices via a console module. For this, both the used console module and the
used computer module must support the us of up to three GenericUSB devices.
For this purpose, UG variants of the compatible VisionXS-IP series are available.
NOTE:
There is one Generic interface on the console module. You need a USB hub
or a USB composite device to connect two or three GenericUSB devices.
The two Keyb./Mouse interfaces cannot be used for generic USB mode.