Gamma Vacuum TSP, Руководство пользователя

Страница: 21 / 27

TSP & Remote TSP Controller Users Manual
21
MPCe Serial Interface, J112 (MPCe Backpanel)
Detailed Command/Response packet information is available in the MPCe manual (PN 900015).
Remote TSP/NEG Serial Commands
Hex
Command
Description
Data Field
Response
Data/Response Interpretation
27 TSP1 TIMED,
Sets TSP1 mode of operation to
programmed. Cycles TSP once
every X minutes, for Y number of
cycles, but only if pressure is
above specified amount.
Applicable to MPCe and legacy
product.
XXX,YYY,
Z.ZE-ZZ,DDD
- XXX is the cycle period in minutes
YYY is the number of cycles
Z.ZE-ZZ is the pressure
DDD is the duration of each firing is
seconds
79 TSPX TIMED,
Sets TSP (1 or 2) mode of
operation to programmed. Cycles
TSP once every X minutes, for Y
number of cycles, but only if
pressure is above specified
amount. MPCe only.
N, XXX,YYY,
Z.ZE-ZZ,
A.AE-AA,DDD,
W
-
N is the corresponding TSP (1 or 2)
XXX is the cycle period in minutes
YYY is the number of cycles
Z.ZE-ZZ is the upper pressure
A.AE-AA is the lower pressure
DDD is the duration of each firing is
seconds
W, is set to 1 to ignore pressure
(automatic cycle period)
28 TSP OFF,
Disables TSP firing is all modes
(manual, programmed, and
degass)
-
-
29 FILAMENT ACTIVE,
Sets which filament is active
during TSP Timed
N
-
N = Filament number (1-8)
2A TSP1 STATUS,
Reports how many cycles left and
minutes each filament has been
used.
Applicable to MPCe and
legacy product.
-
CCC,
N- MMMM,
N- MMMM,
N- MMMM, and
N- MMMM
CCC = number of remaining cycles
N = filament number (1-4)
MMMM = total minutes of filament
use, 0 if degassing, 9999 if open
65 TSPX STATUS,
Reports how many cycles left and
minutes each filament has been
used. MPCe only
R
CCC,
N- MMMM,
N- MMMM,
N- MMMM, and
N- MMMM
R = the corresponding TSP (1 or 2)
CCC = number of remaining cycles
N = filament number (1-4)
MMMM = total minutes of filament
use, 0 if degassing, 9999 if open
2B FILAMENT CLEAR,
Executed after degassing
Resets logged time of all filaments
to zero
-
-
-
2C FILAMENT AUTO1,
Automatically advances to the next
filament if the one being used is
open.
Applicable to MPCe and
legacy product.
“YES” or “NO”
- -